Tips on making photo crystal

 
Here I would like to give some my own suggestion on making photo crystal and hope that it can help the friends who are in making photo crystal line.

To make good photo crystal, you’d better pay attention on following matters.
1Please make sue that you are in a ventilated and clean environment. Cause crystal is transparent, you cannot make it dirty. Moreover, If the environment is too hot, the glue is easily dry which will affect the photo crystal making.
2.Make the crystal surface clean and dry. Or it will affect the result.
3.Don’t touch the film with image in case of making it dirty and blurring the image..
4.When you dip the glue on to the crystal surface, please try to make the glue spring on the core of the surface and then use a flat card to make the glue even over the surface. Notice: See clearly to make sure that there is no bubble. If there is bubble, please press the card to make the glue even. Especially when you sprinkle the 8989 glue, you should take more care to make the glue even in case of any bubble.
5.Don’t make the glue sprinkled on the crystal surface exposed to air long. After you sprinkle glue onto the crystal surface, immediately use the film(without membrance) to cover it and use flat card to flatten the surface.
For beginners, it is unavoidable to meet some problems. Frequent practice is needed to make beautiful and perfect photo crystals.

Welcome any comment and advice from you. It would be nice for us to exchange our experiences for better technique!
Please note, although no boardcode and smiley buttons are shown, they are still useable